XSeries-forum

Looking for some help with PDC problems - replaced faulty front sensor but PDC fault beep still persists (all sensors clicking).

Usual beer token arrangement available 

Kev

Hi and welcome to the forum.
Unfortunately the scanner doesn't always pinpoint which sensor is faulty, unless its totally dead, if they are all clicking it might struggle to pick which one is faulty.
Hope you get it sorted, I ended up getting my own scanner as they are only £30 off EBay.if you only use it a couple of times it pays for its self in convenience alone.

If you fancy popping over to Bassingbourn Nr Royston I'll happily plug you into our Bosch KTS system I use at our garage, It successfully picked up the faulty sensor on my X5.

[quote="Kev0"]
Looking for some help with PDC problems - replaced faulty front sensor but PDC fault beep still persists (all sensors clicking).

Usual beer token arrangement available 

Kev
[/quote] Good luck, been trying to sort mine for the last 6mth, showing  no faults on my 1.4 scanner  all sensors ticking,  :wall:

INPA shows the detection range for each sensor and will show which is triggering it.

I think Navcoder also does this (from research) but cannot say for sure...