XSeries-forum

Hi all I'm wanting to spray my carbon bike frame like the one in the pic , I am a sprayer but only on wood and I am wanting to know the best method to spray the red then black or vice versa ??? Many thanks Paul

Well I'm no pro so may get shot down but do a lot of diy bodywork on anything but the x5 but I think if I were attempting to replicate that I would spray the whole thing red, then leave a while then mask up the red flat off where the blacks going then spray the black, before flatting any edge back and clear coating it all, may be wrong but that's how I would attempt it!

That's what I've been thinking just paint the area red that are going red the tape up ?

Yeh well I would do that because its about 50\50 coilour wise but black will cover red a lot easier so I woul do the light colour first

Just buy an on one frame, there carbon and cheap.  I have the same frame in black and grey and looks really good with all my black and silver goodies

This was the frame before I broke it (

All sprayed

comin out real nice..

carbon frame - how did you fix it?

To properly fix it with carbon was £200 + I fix it with resen glue from work , that's why ivechad to spray it cos you could see the repair ( but it cost me nothing