Page 1 of 1

fitting my amplifier.

Posted: Wed May 02, 2012 12:57 pm
by troy.wyse
i cant work out white wires i need to cut into for audio feed or remote. searched and found a link but thats for when the amp is under cd changer not in the boot under spare wheel and wires are different

Re: fitting my amplifier.

Posted: Wed May 02, 2012 2:42 pm
by Sanj
From your quadlock on the RCM (Radio Control Module):

Rear Left
+Yellow w/ Violet stripe
-Yellow w/ Grey stripe

Rear Right
+ Blue w/ Violet stripe
-Blue w/ Grey stripe

Remote
Violet w/ White stripe

Re: fitting my amplifier.

Posted: Wed May 02, 2012 5:35 pm
by troy.wyse
Cheers sanj. Has Tom been to get the exhaust yet?

Re: fitting my amplifier.

Posted: Wed May 02, 2012 11:51 pm
by Steamyrotter
Just a note...

If you have Bluetooth via ULF and want shot of the original amp arrangement then you will need to connect to the FRONT outputs.

The bluetooth / SRS goes through them.......

I found out the hard way :)

Re: fitting my amplifier.

Posted: Wed May 02, 2012 11:54 pm
by Sanj
[quote=""troy.wyse""]Cheers sanj. Has Tom been to get the exhaust yet?[/quote]

Afraid not. :cry:

Re: fitting my amplifier.

Posted: Thu May 03, 2012 2:36 am
by troy.wyse
[quote=""Steamyrotter""]Just a note...

If you have Bluetooth via ULF and want shot of the original amp arrangement then you will need to connect to the FRONT outputs.

The bluetooth / SRS goes through them.......

I found out the hard way :)[/quote]

Cheers mate but I'm keeping original amp the is just to wire in my sub and amp.

Sanj he will be getting it this week because his parents are bringing it back down to me at and they are up there this weekend. Sorry for all the pissing about