Page 1 of 1
Scanner 1.4.0
Posted: Mon Feb 13, 2012 11:46 am
by nujon
Just bought one of these - I can scan for and clear fault codes OK but cannot access any of the 'tick' screens to enable options eg auxiliary heating on/off/timed from the OBC - how do I do this?
Re: Scanner 1.4.0
Posted: Mon Feb 13, 2012 12:07 pm
by fenj66
Double click on the name of each module to open up that module and take it from there.
Re: Scanner 1.4.0
Posted: Mon Feb 13, 2012 12:45 pm
by nujon
[quote=""fenj66""]Double click on the name of each module to open up that module and take it from there.[/quote]
Thanks - but does not work - that comes up with data input request boxes that I can't answer - no options selections screens appear - anyone got any screen dumps of how exactly one enables options from 1.4.0?
Re: Scanner 1.4.0
Posted: Mon Feb 13, 2012 8:32 pm
by nujon
[quote=""fenj66""]Double click on the name of each module to open up that module and take it from there.[/quote]
Sorted - did not realise that only certain modules (eg the IKE) have a drop-down menu allowing recoding
Thanks again