Page 1 of 1
reset break linning light
Posted: Mon Mar 21, 2011 6:18 pm
by jap scrap
i just fit new break pads and break wear sensors but the message still comes up on the dash is there a way to reset this other than going lock to lock after starting engine
Re: reset break linning light
Posted: Mon Mar 21, 2011 6:26 pm
by pvr
No reset required ... There must be an issue with one of the sensors still.
Re: reset break linning light
Posted: Mon Mar 21, 2011 7:46 pm
by fenj66
drive car for a while. the sensors should reset by themselves after a little while of driving.
Re: reset break linning light
Posted: Mon Mar 21, 2011 8:56 pm
by jap scrap
Cheers fellas i will drive it for a day or 2 and if it has not gone off i will look at the sensors again is there any way to determin if it is the front or rear sensor that is giving trouble