Mirror puddle lights
Posted: Sun Sep 28, 2014 9:00 am
Hi just a quick one how do you change bulbs in mirror puddle lights thinking of upgrading bulbs
Page 1 of 1
Re: Mirror puddle lights
Posted: Sun Sep 28, 2014 1:31 pm
Think you have to remove the mirror back to gain access.
Re: Mirror puddle lights
Posted: Sun Sep 28, 2014 9:42 pm
[quote="TimX5"]
Think you have to remove the mirror back to gain access.
[/quote]
Correct - have a butchers at threads (with pics) on this already.
Think you have to remove the mirror back to gain access.
[/quote]
Correct - have a butchers at threads (with pics) on this already.
Re: Mirror puddle lights
Posted: Tue Sep 30, 2014 9:20 pm
Just had my mirrors in pieces (on going folding issue) and can tell that you that LED/SMD bulbs don't work, you'll need can bus compatible ones as mine powered up but immediately shut off. Its because they fade on and off and are controlled by the lighting module. In answer to your original question use a thin flat plastic trim tool prise at the lower corner of the trim nearest to the window. Once it's loose gently work along the bottom edge and up the side, then pull the top section away. It uses a 501 capless type bulb and is on a white 2 pin plug. Unclip the connector and twist the bulb holder out of the lense.
Re: Mirror puddle lights
Posted: Tue Sep 30, 2014 10:12 pm
Go one weirder than that...
Leave a normal incandescent lamp in one side and a LED in the other and it works ok!!!!
Leave a normal incandescent lamp in one side and a LED in the other and it works ok!!!!
Re: Mirror puddle lights
Posted: Tue Sep 30, 2014 10:18 pm
[quote="Steamyrotter"]
Go one weirder than that...
Leave a normal incandescent lamp in one side and a LED in the other and it works ok!!!!
[/quote]
spooky didn't try that one, must be a current pulling issue. BMW have some crazy ideas when it comes to lighting circuits.
Go one weirder than that...
Leave a normal incandescent lamp in one side and a LED in the other and it works ok!!!!
[/quote]
spooky didn't try that one, must be a current pulling issue. BMW have some crazy ideas when it comes to lighting circuits.
Re: Mirror puddle lights
Posted: Wed Oct 01, 2014 1:09 pm
From my measurements it appears (at the mo..) that they are wired in series with each other!!!
Need to test a little more, but is the only way i can explain what i have seen so far!!
Need to test a little more, but is the only way i can explain what i have seen so far!!
Re: Mirror puddle lights
Posted: Wed Oct 01, 2014 3:24 pm
Sounds about right need a wiring diagram to confirm
Re: Mirror puddle lights
Posted: Mon Oct 27, 2014 11:01 am
on this topic... I popped to BMW over the weekend to buy one and they said it comes with a mirror cover (in prime grey). A bulb or bulb holder/lamp cannot be bought separately... total cost of mirror cover+ bulb )incl. of VAT) is 50.49.
as for mods I've seen some used SMD's (with resistors) or facelift E53 as well as 'projector' lamps with BMW or M logos etc. Not sure re How to's and wiring diagram is applicable but it 'can be done'
.
cheers
as for mods I've seen some used SMD's (with resistors) or facelift E53 as well as 'projector' lamps with BMW or M logos etc. Not sure re How to's and wiring diagram is applicable but it 'can be done'
.cheers
Re: Mirror puddle lights
Posted: Tue Oct 28, 2014 10:16 pm
Smds with resistors should work. Projectors may need the hole drilling out.