Re: New Member
Posted: Tue Sep 17, 2013 3:51 pm
Yes fitted the headrest monitors myself ... headrests just pull out.
You then just need to pop the seat backs off - held by 2 plastic plugs at the base of each one - best to use a trim removal tool for this.
Then just run the wires through the existing holes - install the new headrests - and then there is a small gap in the corner where you can fish the wires too.
One monitor is slaved off the other so they can both watch the same film - but will both work independantly as well.
Next job is to permanently power them off the wires going to the rear ciggy lighter.
You then just need to pop the seat backs off - held by 2 plastic plugs at the base of each one - best to use a trim removal tool for this.
Then just run the wires through the existing holes - install the new headrests - and then there is a small gap in the corner where you can fish the wires too.
One monitor is slaved off the other so they can both watch the same film - but will both work independantly as well.
Next job is to permanently power them off the wires going to the rear ciggy lighter.