Page 2 of 2
Re: NEW GROUP request for detailing
Posted: Sun Aug 04, 2013 2:29 pm
by X5Sport
Try PMing Sp3ctre as he may be able to add it - add pvr and AW8 into the copy list
It does seem like a good idea, and I know pvr is or was out of the country until recently.
Richard
Re: NEW GROUP request for detailing
Posted: Mon Aug 05, 2013 8:35 am
by AW8
[quote="awj85"]
There's a surprise; nothing came of it [/quote]
I detect a hint of sarcasm & suspect you actually might not be that surprised
I note comments re sending PM's but pvr myself & sp3ctre are online pretty much daily. We do read posts & administrate/moderate the site - even if we are quite busy at times.
Pvr replied earlier in this thread albeit briefly............Here's my personal take.
Personally I see little point in having a detailing subsection for the following reasons.
1. There are already excellent detailing sites with plentiful info & discussion. Anything here won't come close to say D.W. boards
2. I see little point in members here folk spending lots of time writing tutorials here when they exist elsewhere. Once again......... Anything here won't come close to say D.W. boards
3. It would be yet another section to administrate when others can be already be used to ask detailing Q's or to post results.
That's my current take on it ............I haven't spoken to pvr or sp3ctre re this
Re: NEW GROUP request for detailing
Posted: Mon Aug 05, 2013 10:46 am
by snipez999
Or just add to this topic LOL
My detailer uses Swissvax in the main
Re: NEW GROUP request for detailing
Posted: Mon Aug 05, 2013 10:48 am
by 535dboy
[quote="snipez999"]
Or just add to this topic LOL
My detailer uses Swissvax in the main
[/quote]
Mine too
Very impressed
I did do the lotus with autoglym myself last weekend to get the rubber marks off and put the sealant on too
Did put a fair carried on but nothing like swissvax
Re: NEW GROUP request for detailing
Posted: Mon Aug 05, 2013 9:55 pm
by shadrack
I detail mine by washing with the hose
Re: NEW GROUP request for detailing
Posted: Tue Aug 06, 2013 9:33 am
by Reusch
^+1
).