Scanner 1.4.0 Settings

[PhilUK]

Found this very useful thread over on E46Fanatics... 

http://forum.e46fanatics.com/showthread.php?t=935613

[X5Sport]

I know this is an ancient thread, but it is still useful, and seems to be a good place to put things like settings.

For those of you who have been using the 1.4.0 for a while, how long does it take to read all of the modules?

I've just run the scanner over one of ours and although there are three pages of modules listed a lot are not coming up as being found even though I know the car has the modules installed.  As an example the 'Cruise Control' comes back as "not found" but the car has it.

Is there a setting I need to change, or is it just I need the engine running or something else?

Richard

[Steamyrotter]

Not used one...
But think you definitely need the ignition in the ON position (Prior to starting) but engine not running.
Carsoft, INPA & NCSExpert wont see all unless the above is done.

Best to have car on a decent charger / PSU when doing anything over a few mins of playing.

[X5Sport]

Cheers.

I had the ignition on, and yes the car connected to a charger too.....been there, done that, felt an idiot!.....perhaps it just needs a couple of tries.

Ta for the suggestions.