RDC disable via bmw scanner

[Y13HYA]

received my bmw scanner. installed fine and reads the car no problems. any guides on how to disable the RDC (tyre pressure system). i cant seem to fathom this....

[Y13HYA]

Anyone??

[Raj]

I looked briefly into this the other week for a forum member after doing some other work. I couldn't see a way to deactivate it but then his was a facelift so uses the ABS sensors and not the valve system.

[Y13HYA]

[quote="Raj"]
I looked briefly into this the other week for a forum member after doing some other work. I couldn't see a way to deactivate it but then his was a facelift so uses the ABS sensors and not the valve system.
[/quote]
i keep seeing people mentioning it can be done but i couldn't figure a way to do it. i.e disable the BC warnings. i managed to code the drive off lock etc no problem.

[Raj]

Ah you just want to remove the check control from the dash?

In that case yes it can be done. Errr now to remember how to do it LOL

[Y13HYA]

[quote="Raj"]
Ah you just want to remove the check control from the dash?

In that case yes it can be done. Errr now to remember how to do it LOL
[/quote]

Correct

[Raj]

Pm'ed buddy.

[Y13HYA]

Thanks
However the RDC wasnt on that screen when i tried last night....

[Y13HYA]

the screen i had looked like this

[Raj]

Do you have a units drop down on the front page for RDC or TPC?

May need to go into that module if available. If not then I'm not sure. I know on the facelift there isn't an option for the TPC module as it doesn't run the delegate valves like pre-facelift.

Sorry cant help anymore than that.

[Y13HYA]

[quote="Raj"]
Do you have a units drop down on the front page for RDC or TPC?

May need to go into that module if available. If not then I'm not sure. I know on the facelift there isn't an option for the TPC module as it doesn't run the delegate valves like pre-facelift.

Sorry cant help anymore than that.
[/quote]

It has RDC unit option but i cant get options on it like i can with the LCM.

[malc1950]

Sorry for some reason it's sent only
One page


Sent from my iPhone 5 using Tapatalk

[malc1950]

Last try
http://www.bmw-scanner.com/?page=bmw-sc ... 0&lang=eng



Sent from my iPhone 5 using Tapatalk

[Horizon]

Hi Malc
The trouble with the screen shots shown on the advert is that it only shows page one of the scan results, its maybe on page 2 or 3. I have seen the option on one of these missing pages but it doesn't show any results on mine, or yours. It says not found on ours, as we have facelift cars. If you scanned a pre facelift car it would find the module I guess. As our cars use the traction control instead, to read the low pressure by difference in rolling distance

[malc1950]

Hi Pete I see what u mean it only opens page one and it could be on two or three, I see your going down to Cosford at the weekend I'm thinking of going around midday for 2 or 3 hours,
I'm out Sat night so can't stop late  ,


Sent from my iPhone 5 using Tapatalk