Post
by Sanj » Mon Aug 02, 2010 2:09 pm
If you have the comms pack with a screen up front it is possible to add a reverse camera. I tried 3 different cameras over the past couple of years and two different locations. I found having the camera mounted in the tow bar cover just wasn’t good to gauge distances. Besides it didn’t look OEM enough. I wanted to see my raer bumper in the reverse angle.
So this is what you’ll need:
1. The camera, my preference is this one
2. Some wiring cable and the wiring diagram
***Use this one***
I removed the rear boot release, 4 screws and then a connector inside to get access to where I wanted it mounted. Just above the rear number plate.
Here is the piece with the colour coded plastic cover removed and the cut outs I made to house the camera.
Once complete you should get something like this.
And the view that comes out on the screen when you select reverse (some cameras will give you the guidelines – they’re not particularly accurate, more a gimmick).
Here’s mine removed and then colour coded recently to match.
Total cost should be no more than £40. Not bad I reckon...
Last edited by
Sanj on Wed Feb 01, 2012 8:24 pm, edited 1 time in total.
Scn Protect,Alarm Chirp,Ashtray del,Sub install,IV2,Screens,PS2 Media,Chrome rings,Schnitzer pedals,Reverse cam,Silver Grills,F/mirrors,Comp Spkrs,Heated S/W,20"168s,Splash scn,Arches,Remap,LED Tails,ACS Spoiler,'is' Bumper Trim,Rear heated seats,Rear blinds