Air suspension inactive after work

[Sirrepairalot]

Hi folks,after recent work on the back end replacing control arms and bushings,I’m now getting the above.i have been raising the rear axle with my scanner but after about 4 days it starts to lower again.getting code saying regulation time fault 1 sided.all I did was disconnect the 10mm nut on the sensors when removing the trailing arms and all worked before.

[henrym3]

Are you sure you haven’t flipped one of the sensors over, make sure they are both pointing in the same direction.

[Alan Gunn]

As above often done and not noticed.

[Suchy1977]

Start with the simple steps first, check the fuse its a 30amp fuse the last one on the right side of the fuse tray i had an issue with my suspension been really rough I checked and it was luckily only a fuse. Hope its same for you.

[Sirrepairalot]

Well defo not a fuse(I wish)and Alan I am gonna be checking sensors when I grab 5 mins