did , my first scan on the obd2

[Ryoken]

# ERRORS DETAILS - DTC(hex)/PARAM(hex)
---------------------------------------------------------------------------------------------------------------------------
ABS  ->  5A/D2 - Temporary system deactivation

SRS  ->  Shadow-memory:
          06/40 - Side airbag, front right door, resistance too high

IKE  ->  BD/50 - Electronic braking-force distribution

PDC  ->  22/C6 - Acoustic generator, front, off

BMBT  ->  16/21 - EEPROM Checksum does not match with programmed value

LRA  ->  Shadow-memory:
          00/00 - Terminal 30


# SCAN END


any got any pointers ??

Steve

[X5Sport]

First edit your VIN out!!

SRS:  The airbag one simply means the system is not happy about one airbag connection.  Could just be bad.  Air bag may not fire if needed in anger.

PDC:  Looks self explanatory.  Front parking sensors look to be switched off.  Had any trouble with them?

BMBT:  on board monitor head may have been changed in the past for a new/used replacement.  The system expects to see one number but it's getting another one so it doesn't recognise it.

Richard

[Sanj]

Mwahahahaaaa, I have his VIN!  >:D

[Ryoken]

deleted everything apart from codes
i know the drivers door cards been removed at some point, so  that could be air bag ( window regulator maybe ?)
pdc..... doesnt work, had a rear drivers out a bit ago which got replaced, all sensors work now but, still get  flashing bdc and long beeeeep.
bmbt. could be i  updated the firmware on the sat nav , could be that?..

dunno

Steve

[X5Sport]

It's a possible with the door card and the air bag plug isn't fully home.

PDC obviously still needs investigation.  If the sensors are all clicking then it could be a module issue, or a wiring fault.

BMBT, no the software change is in the boot so that shouldn't affect the head as it's only taking a video stream from the nav computer.  It may be that at some point the head failed and was replaced?

Richard